Lithium Battery Double Deck High Low-Temperature Testing Chamber Environmental Equipment

Product Description

It is suitable for electronics, instruments, power batteries, home appliances and other products, parts and materials at high and low temperatures.Adaptability test (reliability test) for storage, transportation and use in alternating, high and low temperature environments.

Technical parameters

1. Inner box size (W*H*D) : Double layer, each layer W600*D600*H850 (mm)

2. Outer box size (W*H*D) : W950*D1900*H2150(mm)

3. Temperature range: -40ºC ~ +100ºC

4. Temperature fluctuation: ≤±0.3ºC(constant state space-time load

5. Temperature uniformity: ≤2.0ºC(constant state space-time load

6. Temperature deviation: ≤±1.0ºC(constant state space-time load

7. Rising and cooling rate:
Cooling rate: +25ºC ~ -40ºC≤60min, average cooling rate: (0.7 ~ 1.0) ºC/min(the whole average no-load).
Heating rate: +25ºC ~ +100ºC≤40min, average heating rate: 0.5 ~ 3.0ºC/min(the whole average no-load

8. Common temperature conditions: 60 ºC, 45ºC, 25ºC, 0ºC, -10ºC, -20ºC, -40ºC; It is about 3 months long
Phase low temperature test condition (-40ºC)

9. Equipment layout:
Circulating water inlet and outlet, spray water inlet and outlet are located on the left, pressure relief port is located on the right;
Circulation water inlet and outlet, spray water inlet and outlet are located on the right, pressure relief port is located on the left;
Note: From the position of the main door of the equipment; The device configuration ratio in the two layouts depends on the actual purchase requirements.

10. Equipment volume: 306L (600×850×600 mm) per layer, a total of 2 layers

11. Operation mode: Double-layer independent temperature control, can be set to run or program run.

12.Equipment weight: ≤550kg

13.Voltage: AC 380V±10%, 50 Hz, three-phase four-wire + ground wire

14.Ambient temperature: 0 ~ 40ºC

15.Ambient humidity: < 85%R.H (25ºC)

16.Atmospheric pressure: air pressure 86 ~ 106Kpa

17.Equipment power: 9kw

18.Power distribution circuit breaker specifications: 63A/3P+N

19.Equipment wire specifications: 3*6+2*4 (three-phase five-wire system

20.Device cable inlet: One cable inlet at the top of the device

21.System noise: ≤68dB (500mm from the surface of the equipment and operating bit, respectively)

22.Cooling method: water-cooled (customers provide frozen water

23.Inlet flow rate: ≤2m³/H

24.Water inlet temperature: 5-32ºC

25.Inlet pressure: 0.2MPa

26.Environment heat dissipation: ≤0.3KW

27.Equipment fault protection: overheat protection circuit breaker, humidification system overheat protection, compressor overload protection, control system overload protection
Protection, overload indicator light, phase sequence protection, water shortage protection, high pressure and low pressure protection, over temperature protection, water supply delay protection, fan overcurrent protection.